These standard alarm types are supported in StruxureWare Data Center Operation: PRO Pack.

Note

The alarms with the exact wording as listed are supported. Any alarms with a different wording will not be recognized by the StruxureWare Data Center Operation: PRO Pack.
However, it is possible to customize the critical alarm and threshold configuration for migration of impacted servers.

APC/MGE UPS

  • The battery power is too low to continue to support the load; the UPS will transfer to Bypass. The load will be powered by Bypass AC.
  • The battery power is too low to continue to support the load; the UPS will shut down if input power does not return to normal soon.
  • The battery power is too low to support the load; if power fails, the UPS will be shut down immediately.
  • Lost the management interface-to-UPS communication while the UPS was on battery.
  • The load exceeds 100% of rated capacity.
  • A battery fault exists.
  • On battery power in response to an input power problem.
  • The UPS failed its diagnostic self-test, due to either an overload or poor battery health.

Symmetra MW:

  • Alarm low battery warning.
  • Alarm Overload.

Liebert

  • The system has detected an overload condition.
  • The system has performed an emergency transfer to bypass.
  • This system has detected an overload condition.
  • This system has detected Output to Load is in an overload condition.
  • This system has detected Output overload condition.
  • The system has detected a self-test failure.
  • Overload error present on at least one phase of static bypass switch.
  • The battery capacity is low.
  • The system has detected a battery low shutdown error.

APC Coolers

InRow RC:

  • Cooling failure exists
  • Condensate pan full fault exists
  • On standby, input contact fault exists

InRow RD:

  • A cooling failure exists.
  • A unit type conflict alarm exists.

InRow RP:

  • Cooling failure exists.
  • On standby, an input contact fault exists.
  • High discharge pressure alarm exists.
  • Compressor drive fault exists.

InRow SC:

  • Cooling failure exists.
  • A persistent high discharge pressure alarm exists.
  • A persistent low suction pressure alarm exists.
  • A startup low suction pressure alarm exists.
  • A startup line pressure imbalance alarm exists
  • On standby, an input contact fault exists.

See also

StruxureWare Data Center Operation: PRO Pack

Skip to end of metadata
Go to start of metadata
RELATED COMMUNITY QUESTIONS
WAS THIS ARTICLE HELPFUL?